You will need
  • Set the SATA disk, computer.
Instruction
1
The main characteristics of the disks:

- The SATA cable has the same connectors. One connector leads to the motherboard, the second directly to the hard drive. Improper connection of SATA-disks is an impossible operation;

SATA drives do not have the presence of a jumper connection is very simple.
2
In order to connect a SATA disk, you must:

find the appropriate connector on the motherboard;

- connect a jumper cable;

to connect with the hard disk;

- connect the power cable to the hard drive (you'll need a special cable supplied with the hard drive). Sometimes comes with the adapter.
3
In order for your operating system can see the new disk, you must set the operating mode of the disk.
4
Close the cover of the system unit, if it was open, and move to the power supply.
5
Turn on the system unit when the computer boots, press the Delete button.
6
The screen displays the BIOS Setup – go to the selection tab of the options installed devices – enable SATA mode.
7
When you install any operating system requires an additional driver for your drive. However, some versions of operating systems are already equipped with such drivers.
8
When installing the hard disk with the installed operating system, drivers load into the system after turning on the computer and the appearance of the welcome screen.
9
Sometimes it happens that you are advised to buy in store hard drive format SATA, but your motherboard does not support it. In this case, you need to purchase a PCI-Board for commutation of the hard disk in your system unit.