How to bind a float

Install the fishing line slip bobber with bottom mounting point. Products of this type are called "Valery" (wagglers). They are designed for long casting, which is usually spinning rod with a spinning reel. The float should move freely on a small segment of the line between the two stoppers, which constitute the sliding knots, beads or lead pellets. Determine the required depth of immersion of the hook. Measure the desired distance from the end of the line. Received in place to secure the upper stopper. Miss the end of the fishing line through the attachment point of the float (usually carefully ground the hole or metal loop). Fasten the lower stopper near the end of the fishing line, leaving a margin for sinkers and tying the hook.

For fixing "Valero" constant fixation need a rubber sleeve. Due to the ease of application today, such products are becoming more common. In contrast to the sliding of the floats, they are very light. Their structural feature is the presence of small plastic clamp threaded through the lower mounting loop. Cut the rubber cambrica suitable diameter length of 0.7-1.5 cm Skip through the end of the line. Insert the clamp float in the sleeve. If the clamp is missing, a valid dressing cambrica right at the end of the keel of the float, if it has a small diameter.

Secure on the fishing line float with two attachment points (according to the international classification it will be type stick floats). Bright representative of floats of this type is a common quill pen, and even with specialized stores offer a wide range of plastic counterparts. Cut two narrow rings of rubber or vinyl chloride cambrica. Thread the fishing line through one of the rings. Put it on the antenna of the float. Thread the fishing line through the second ring, pull it to the keel. If the fin has a mounting loop, pass the line through it.

Floats for fishing fly rods (pole floats) are quite expensive and high-tech products. But they are increasingly used by domestic fishermen. On the upper part of their body is usually there is a small wire loop. When attaching the float first, skip the line through it. Cut the rubber cambrica of suitable diameter, length 0.5-0.7 mm. pass through it the fishing line and pull it to the keel. Miss the end of the fishing line through the loop in the keel.