How to pull the string in the eaves

From these ledges, there is one drawback — over time, the string is slack. But this problem is easily eliminated. Typically, in such rods there is a special bolt for tightening sagging strings. String curtain are also double row to hang the usual classic shades. As the strings are steel wire, which is attached to the side surface of the wall with the bolt. The hole for the bolt holding the drill in the legs of the ledge at a distance of 2/3 of the height from the bottom edge and 1/3 of the width of the crossbar. The right holder ledge is one of the components of success further string tension.

For tension, use a bolt with a drilled head. Insert it through the stem, the washer and slightly tighten the nut. One end of the strings pass through a hole in the head of the bolt and tie on the other hand, pre-pulling. Then do the same on the other side of the cornice: pass through the second leg, the washer and also tie.

Then pull the string until the desired degree of elasticity. Curtains from easy air fabrics look best on the string. These curtains are very handy. They are especially good on the Windows of the attic with a stone sill. But that string was permanently stretched, it should be carefully mounted. The string can be pulled not only Windows, but also between opposing walls. In this case, the curtain will be a partition or screen. Some types of the string of rods is equipped with hinged brackets. This will give you convenience in case you want to install in your home string cornice. In any case, the most important thing is to properly tighten the cable so it does not SAG.