Each time after bath and whirlpool rinse the whirlpool surface and gently wipe with a soft, lint-free cloth. For everyday surface cleaning that will be quite enough. Please note: it is not recommended to use in the process of cleaning, Jacuzzi cleaning products and scrubbing pads.
Once a month carefully disinfect and clean Jacuzzi. For this you first need to fill the bathtub with water. Make sure that the water level was approximately 5-7 cm above the top of the injectors. Then add the water special disinfectant solution. This solution can be purchased at the store or make yourself. If you bought a special tool for cleaning a Jacuzzi in the store, be sure to read the operation manual and strictly follow. If for any reason the use of such funds is impossible, prepare and pour in water to about 70 ml of a weak solution of chlorine.
Turn on the pumps, wait a couple of minutes and then turn off. Wait 15-20 minutes, then drain the water. Again, fill the tub with water, turn on for 1-2 minutes, the pump, and then turn them off again and drain the water. Then carefully remove the filters and clean them. If you don't know how to do it, read the manual of your model Jacuzzi. Having cleaned the filters, put them in their place, and then wipe the surface of the bath with a soft cloth.
About once a year to carry out extra cleaning Jacuzzi. Fill the bathtub with warm water so that its level was 5-7 cm above the upper injectors and then pour in the water, a liter of acetic acid. It is recommended to take the 7% solution: it will help to clean Jacuzzi from the deposits of water stone and it will not damage the surface of the bath. Turn on the pump for 30-40 seconds, then leave the water in the tub. After 12 hours drain the water, refill the tub, turn on the pump for a few minutes. Again drain the water, rinse the tub, then wipe with a soft cloth.