You will need
- For the construction of the toilet you will need:
- - shovel (shovels and bayonet);
- - brick red;
- - cement;
- - sand;
- - 2 oak logs with a length of 1.5 meters;
- the eaves of cut 1 cubic metre;
- - bar 5 4 cm;
- - plywood, 11 mm;
- - jigsaw;
- - nails;
- - 1 sheet of slate.
Select the location where you will build the toilet. It needs to be somewhere in a corner of your plot in a secluded place at a distance of at least 10-15 meters from the house. Mark hole 1 on 1 meter. Bayonet take a shovel and start digging. Remove the earth layers to a depth of bayonet spade, occasionally raking the ground shovel. The depth of the pit should be no more than 1.5 meters. If you dig it deeper, in winter, it will "float" due to the heat of the earth. When you reach a depth of about 1 meter, the ground pour in the bucket, and your assistant, with the help of a rope let out to the surface.
Prepare the bricks and mix cement-sand mortar in the ratio of 1 to 3, i.e. 1 bucket of cement to 3 buckets of sand. The first row of bricks in the pit lay flat. Then to the top, put a brick on the edge, carefully laying it along the walls of the pit. Upstairs make a smooth surface on the edge of the pit. Put the prepared oak logs hewn with smooth top surface above the pit, at a distance of 20 cm from the edges. Continue laying bricks now on, how would zamurowywania of the logs in the walls. The height of masonry should be on the thickness of the logs.
Now take the Board thickness of not less than 40 mm and make the floor of the toilet, covering the hole. Mentally divide the floor of the toilet into 3 pieces at the rear to make a square hole, vypilivaya for Paldiski. Its size is approximately 15 by 15 cm nail around the perimeter of the floor timber. You have a square, make the dressing frame house from a bar front, don't forget to make the doorway. Frame is better to collect using the screwdriver and screws, but nails. All panel boards, tightly fitting them to each other. Make the door, hang it on hinges, put door knobs, hang a hook on the inside.
Proceed to the construction of the main part of the toilet – seat so called. Surmount a thick plywood cube without a bottom, with sides of 40 cm Take regular toilet ring on the toilet, attach to the top of the cube, draw the neck, saw it with jigsaw. You get a delicate hole. Put this wooden toilet seat over the hole, fasten diagonally across the nails or screws to the floor. Buy store unitatea ring with lid, attach it to your toilet. The last thing you need to do is the roof. Put up a sheet of slate, it is the standard size of 125 to 175 cm Nail it to slate nails. Your toilet is ready! In order to avoid odors buy special filters for home toilets.
Better don't do this in the bathroom ceiling,since the natural pull of air between the waves of the slate removes all odors.
around the toilet, do the concrete pavement.