You will need
  • Remove fresh foam
  • - a special liquid for rinsing of building guns
  • - liquid varnish remover
  • - vinegar
  • - rags
  • - cotton pads
  • Remove dried foam
  • - special tool to remove the hardened foam
  • - brush
  • - spatula
  • - rags
  • - the drug "Dimexide"
  • - a kitchen sponge with a hard side
  • knife
  • - toothbrush
Instruction
1
Remove fresh foam.
Mounting uncured foam from the surfaces remove special liquid for cleaning guns. Check the action of this tool on the material in inconspicuous place. If the surface remained resistant to the aggressive environment that does not damage the top layer is not peeled off the paint, then wet means rags and scour fresh installation foam.
2
Small drops of fresh foam to remove liquid varnish remover. Moisten a cotton pad and wipe the contaminated place.
3
The foam that came in a glossy or matte tile, removed vinegar. Pour on a rag vinegar and place it on the contaminated area. Leave for 5 minutes. Then wipe the same cloth.
4
Remove the dried foam.
For dissolving dry foam buy a special tool at the hardware store. The packaging tools should be instructions for use. Usually such products are sold in the form of paste or gel, are applied to the surface with a brush and then removed with a spatula together with the softened foam. Do not forget to check the effect on an inconspicuous area of the surface.
5
A thick layer of foam cut with a knife, then gently otkolupyvala little piece of foam, so as not to damage the surface of the material. Take a dry kitchen sponge. Her hard side, slowly, scour the remains of dried foam. Take your time so as not to leave scratches.
6
Buy the drug "Dimexidum". Dampen them with a cloth. Put a rag on zapenennye area for a few minutes, careful not eroded the surrounding surface. The softened foam will clean off the blunt side of a knife or an old toothbrush. The drug clears both old and fresh foam.