You will need
- - square wire
- - round wire of a smaller diameter
- - beads
- - pliers
- - pliers
- - transparent adhesive
Instruction
1
Using the pliers, separate the square from the roll of wire in 5 lengths in 23 cm From each edge, measure 2.5 cm and mark with a Sharpie. Grab tip of wire with pliers and twist flat spiral up to the mark. Repeat on the remaining pieces.
2
Place the segments of wire close to each other. Make sure that of the underlying edge. Measure a piece of round wire is sufficient for 6 turns around core segments. Make a wire hook on the end of a thin wire, put it on a square piece starting from the base of the spirals make 6 turns. The beginning and the end of the round wire must be on the same plane – this is the inner part of the bracelet.
3
Measure 2.5 cm and lightly fold one square of the wire on each side, put them on busine and again connect all the elements. Cut a piece of round wire and obvate base as in step # 2. Follow the ends of a thin wire – they must be on the same side.
4
Mark cut in 8 cm. Fold the square rods of the segments and string on each wire with 5 beads. If you want to lock a certain position of the beads, use a transparent glue. Again connect the elements in one bundle at the marked point. Repeat the winding in 6 turns of thin wire.
5
Repeat steps 3, 2 then fold the ends of the wire in a spiral as in step 1. Give your bracelet a semicircular shape, and wear with pleasure and pride.
6
Using this method, but varying the size and number of beads, you can create unique bracelets with your hands.
