You will need
  • Board with a thickness of 1-2 cm;
  • - 2 rails with a cross-section of 0.5 cm and a length of 10-12 cm;
  • - thick thread or twine;
  • paper;
  • knife;
  • jig - saw or a regular electric;
  • - 2 small cloves;
  • - scissors;
  • - sandpaper;
  • - the file;
  • glue BF or nitrocellulose;
  • - oil paint.
Instruction
1
Draw on the Board the ship hull. For flat-bottomed vessel, measure a length of 15 cm and a maximum width of 6-8. The sailboat should be wide enough, it will provide him stability. Saw out the contour of a rectangle. Divide the short side in half and slide longitudinal axis.
2
Determine where your boat will nose. Back away from the edge along the long sides 5 cm and make a mark. Connect them to the middle of the nearest short side. Nasal corner Express sharp, and the cheekbones better rounded. This will provide the desired flow.
3
From the stern back on the sides 3-5 cm Connect the resulting points with a smooth curve, convex part of which is directed backwards. Make sure that the stern line was symmetrical. Saw out with a jigsaw, the hull on the drawn contours. Aft along the longitudinal axis to make a jigsaw propyl length 1 see Here will be attached to the wheel.
4
Decide how many masts will have your boat. It is possible to do with one mast or two-mast. From single-masted sailboat along the longitudinal axis at a distance of 7 cm from the nose mark. If you want to make 2 mast, make a mark at a distance of 6 cm and 11 cm from the nose. Using a knife in these places, decks, make a short longitudinal incisions. Each rail with one end sharpened in the form of flat blades so that it is inserted into these incisions.
5
The rudder was fabricated from the wafer, cleaved with a knife scraps from the same boards from which you were cut body. The wheel should not be too large. Its length is about 3 cm Paste it into propyl. It must be tight and protrude below the hull by about 2 cm. Optionally, secure the wheel with glue.
6
Cut out sails from paper. In this case, they represent the rectangles. The width of the sail must not exceed the width of the building. On one mast can be 1 or 2 sails, the upper smaller than the lower. Make the rectangles in the 2 hole. Put sails on the mast. Insert the mast sharp ends into the slots of the deck. For durability they can also be secured with glue.
7
Secure stud on the nose end of the twine. Route it along the tops of the masts so that the slats rested on thread. The other end fasten a nail on the stern. Put the ship on the water and see sustainable or not. If the ship is unstable, shorten the mast. This is usually not required.
8
After the test, remove the sailboat from the water. Let it dry and paint with oil paint. The mast painting is not required.