How to transfer image on wood

If you are a lover of all kinds of crafts, then I think you will like this. I suggest you do a very unusual creation - to transfer a photo to wood. To be honest, I had the opportunity to learn about this work is not very long, but it I was immediately captivated.

You will need

• Board;
• photography;
• - laser printer;
• - fine sandpaper;
• - PVA glue;
• - acrylic lacquer;
• - sponge;
• - warm water;
• - acrylic paint.

Instruction

1. So, first you need to zoom in to the required size, then print it is certainly on a laser printer so that you get a reverse image.
2. Now it is necessary to prepare a wooden Board on which the transferred image. It is necessary to process an emery paper to remove all roughness and irregularities.
3. Then, the treated surface of the wooden boards you need to cover with PVA glue. If not, you can use acrylic varnish, but it's better to apply the first.
4. Next, the printed photograph should be put on a wooden Board so that the image was at the bottom. The printout carefully smooth out with a sponge and squeeze out all the air. From this procedure depends on the quality of DIY, so do everything very carefully, slowly.
5. After the printout is overlaid on a wooden surface, you need to give her time drying. It dries in approximately 12 hours.
6. After a time, remove the paper from the Board using warm water and sponge. Do not worry if the paper is poorly removed with a sponge. In this case, you can simply roll your finger - the image will be nothing.
7. Once the image has dried, it must be covered with acrylic paint, then let it to dry completely. Transferring photos to wood is complete!