Instruction
1
Dismantling of car front bumper Peugeot 406 start by removing the front headlight. Then raise the front of the car and lock it, setting the stand. For removing inner fender wheel arch, Unscrew the screws holding them to the front bumper. Then separate the fender liner from the bumper and remove bolts attaching them to the body.
2
If the vehicle is equipped with fog lights, loosen the clamps attaching them and disconnect the electrical connectors from the wires. Remove the bolts securing the bumper: two on top and three on the bottom. Find it in the jacks lights locks and release them by turning 90 degrees. Disconnect the front bumper from vehicle by pulling it straight forward.
3
To remove the back bumper on the car Peugeot 406 sedan Unscrew the screws located on the inside of the Luggage compartment and remove the inner rear of the trunk. Remove the panel mounting left and right corners of the inner trim of the trunk by unscrewing their securing screws. For removing caps of fastening, remove the Central pin, the retaining caps themselves. Then remove the side trunk trim to access the mounting of the bumper.
4
On cars with a body a hatchback, open the rear door and remove the interior trunk trim from the base and sides. Remove the rivets attaching the side trim of the trunk to the floor. Loosen bracket and remove the plastic glove box.
5
On all models, remove the ventilation Assembly with the right rear corner of the trunk by unscrewing the screws of its fastening. From the bottom of the car Unscrew the screws attaching the fender liner to the bumper. Tilting the wheel arches from the bumper, Unscrew the nuts fastening the ends of the bumper to the body, and then the mounting nuts to the bumper. From inside the trunk remove the six nuts fastening the top of the bumper.
6
Disconnect the connector with the wires for the license plate light located at the left of the reversing light. Remove the rear bumper, freeing the ends and o-rings wire license light.