How to charge the capacitor

When you install the car audio system powerful, sometimes it is necessary to connect the capacitors of large capacity. Each time, after removing the car battery, procedure must be performed to charge the capacitor. Also charging is required for initial installation of the capacitor.

You will need

• A constant current source (vehicle battery). Resistor, supplied with the condenser or a 12V light bulb if it is not.
• Wires for connecting the capacitor of the same section, and wires for power connection.

Instruction

1. Make sure that:
   terminal of the capacitor " + " connected to the power wire of the amplifier;
   terminal of the capacitor " - " is connected not to the amplifier and to ground of the car.
2. Gently remove the audio fuse.
   Disconnect the wire from the terminals of your capacitor is marked with "+"
   Connect your power source to the network (we have a car battery).
   Connect the supplied capacitor resistor one terminal to the capacitor terminal marked "+".
   Repeat the above step, if you connect it through a 12V light bulb.
   The other contact "-" connect to the power cord.
   Repeat the above step, if you connect it through a 12V light bulb.
3. Reconnect the audio fuse.
   Wait at least two minutes, after which the resistor is required to disconnect, and the wire feeding the capacitor, to connect to "+" terminal directly.
   When connecting through a resistor, the charging time of a capacitor determine its technical documentation.