By EasyHow
How to put the battery in the car
The battery is an important component of automotive electrical equipment to allow starting of the engine. The ability to correctly install the battery will be useful for every car owner.
Instruction
Be sure to check whether the battery and sealed it. Especially if the battery is not new. If you have just bought a new battery, then you can skip this step. Of course, if you are confident of seller.
Install the battery on a special pallet, which is located under the hood. Place the battery so that the terminals were in close proximity to the contacts where you will join them. In some vehicles the battery is not under the hood, and, for example, under the rear seats.
Apply terminals to the contacts. To avoid confusion, remember that the negative pole of the battery is connected the black wire and positive to red or blue. Inspect circuit. Take a wrench and tighten the bolts on the terminals. The nuts on the back side also hold the key. When working with battery, wear safety glasses to sparkle for the eyes.
Note
Terminals should be tightened as the contact is not lost. Screw the tight. Otherwise the starter will not get the required power and the vehicle will not start.
If you are going to put the car into the Parking lot for a long time, loosen or disconnect the terminal with the sign "minus". Then the battery is discharged.
If the battery is dead, it has to be recharged using the charger. Better to do it in the garage, and if not, then on the balcony – when charging are harmful to human couples.
Useful advice
When installing the battery follow that there is no short. If this happens, then either you hooked up the battery wrong, or the wiring is damaged. Do not confuse the circuit and the operation of the relay-breaker. If there is a sound like a click, then check off all system: not included light not included if lights do not work the wipers. Everything should be off.
