Instruction
1
If the VCR lamp, find online or in the instructions it information about how it applied to the power supply. Instead of the network transformer can be installed auto-transformer or powered directly from the mains through a rectifier. Such a tape recorder to use as an amplifier it is impossible in any case. Also not suitable for use as the amplifier of any tape recorders set-top boxes, but for a different reason: they require connectivity to external amplifiers.
2
Most convenient for use as amplifiers, tape recorders that have inputs for external signal sources. Select the one that is designed for the connection of the pickup. Buy or make a cord, one end of which is a 3.5-millimeter stereo jacks and another connector corresponding to the set on the VCR socket (a 3.5 or 6.3 mm Jack, RCA, DIN). To combine the stereo channels when you connect a stereo source to monaural tape recorder, you have two resistors is 1 kilo Ohm. One conclusion of the first resistor, connect the output of the left channel and the second exit to the right. The remaining insights connect with each other, and the signal from the point of their connection feed to the input of the tape recorder.
3
When connecting to the input DIN mention that one of the tape inputs of the stereo channels located to the left of the middle, and the other to the right, depending on when released camera. Turn on the tape recorder in the recording mode without reels and cassettes. Have a cassette recorder will have before switching to the recording mode, press the lever of the sensor cassette. You can submit an empty case from the magazine, which is not broken (or broken, but taped) the tabs write protect.
4
On a cassette recorder with no inputs for external devices (including the car stereo) signal via the adaptor in the form of a cassette. Place the adaptor in the tape mechanism and play it (in any case, do not record, however, on the car stereo this mode is usually not). Plug the cord coming from the adapter, turn on the signal source. If you do not have a tape recorder and radio with the FM band, you can use an FM transmitter. Transmitter set to a free frequency, and the radio will switch to receive mode and set to the same frequency as the transmitter. Apply to transmitter power, and then insert the USB flash drive or memory card with music files (he will work as a player) or connect the cord to another source.
5
A tape recorder, which no longer plans to use for its intended purpose, can be subjected to alteration. The signal feed through capacitor of 0.05 - 0.5 UF relative to the common wire on the output of the volume control, the opposite is connected to the common wire. Unplug the wires going to the engine, and jumper contacts mode switch that supplies voltage to the audio amplifier so that the power for this amplifier was fed constantly, even when the buttons are pressed.