The power increase of the engine VAZ-2106 is a necessary thing when tuning. The car should be attractive not only externally but also internally. The engine needs more horsepower, and the speed was higher, and acceleration, and traction. There are two ways to improve the performance of the motor. The first is the installation of the turbine, it can add a lot of horsepower to the engine. And the second way is to upgrade all nodes of the motor. But the best option is the combination of the first and second.

What is a turbine?



It is worth to mention that the good work will be turbine in the injection motors. Carbureted engines only get worse you'll feel after the installation of the turbocharger. The turbine is an Assembly, which includes impeller, driven by the force of the exhaust gases, and a compressor pumping air. Accordingly, the impeller is installed in the exhaust manifold.

The compressor inlet is connected with the filter of zero resistance and the output from the power supply system of the vehicle. The shaft rotates at speeds of several thousand revolutions per minute. The specific number depends on the manufacturer of the turbine and its model. This is enough to pump the air under high pressure. Thanks turbine, you can increase the power of a standard engine by 2-3 times.

Sort out the engine



But to put a turbocharger on the engine, long outdated, needing repair, not very reasonable. So you should iterate over it and replace almost everything. The most important thing – that piston group. You can buy the lightweight pistons, and it is possible to reduce the weight of the standard independently. Really needs the assistance of a qualified Turner if you have no relevant skills.

Grind off the skirt of the piston from the inside, just try not to compromise the integrity of the part. Cut the skirt completely is not recommended because it will affect the position of the piston in the cylinder during engine operation. The piston can slightly lean, causing the motor will jam, and in this case, it is inevitable repairs.

Next in line the connecting rods and the crankshaft. These nodes also need to facilitate. And you can't do without a lathe. The engine flywheel should also whittle down from the inside. The VAZ-2106 the flywheel is very heavy, the engine is hard to spin it, so you lose a lot of power.

Do not forget about the balancing of the crankshaft and flywheel. If you do not do this, then the vibration you will be provided. And take care of the lubrication and cooling of the engine. Install high-performance oil pump. Motor lubrication now will need in large quantities. And as the fan of a radiator it is best to use one in which a greater number of blades. You can also find a pulley for a smaller diameter pump to pump coolant faster rocked.