This scheme is good in its simplicity, it is not necessary to use expensive components, and the number of wires is minimal. But there are also disadvantages from her. For example, a temperature sensor, acting as a switch, passes through a large current, which affects his life. And another minus is a sharp turn on the engine. The load on the motor increases sharply to a maximum value, and this negatively affects the condition of the motor.
The use of electromagnetic relays
Application of a simple relay slightly complicate the scheme, but will spare temperature sensor from the presence of a large current. A large current will flow through the relay contacts. Cheaper and easier to replace relays than the temperature sensor to activate the blower motor. For the upgrade you will need wire and relay with bracket for mounting to the body.
Disconnect the temperature sensor, and the wires that were on it, you need to connect to the normally open pair of contacts of the relay. Half the work done, the power part is ready. Now management. One lead of the temperature sensor is connected to the ground, but the second connected to the relay coil.
From the second output coil need to stretch the wire to the positive terminal of the battery. It is desirable that the connection was performed through a fuse, the value of the current operation which may be 1 Ampere. Coil consumes small quantities, so the worst thing that can happen is a short circuit in the wiring. Subsequently, in parallel to temperature sensor connect button forced on that install in the car.
The use of semiconductors
Instead of an electromagnetic relay you can use a thyristor key, or the design of FETs. The essence is the same, only there are no moving contacts, they are the functions of electrons and holes in a semiconductor crystal. But don't forget about the cooling of thyristors and transistors, attach the radiators, which will be able to provide the necessary heat.
Softstart is a very useful feature for motor control. This innovation will provide a gradual increase in load on the motor. This idea is carried out by applying PWM modulation. But with all the innovations can be used in the cooling system of the second temperature sensor, whose temperature 5 degrees less than the main.
If the operation of the main sensor the fan turns on at full power, then when triggered, the second sensor engine speed should be halved. For this connecting will have to use a resistor. Perfect the that is installed on the fan heaters. This will not bring the temperature in the system to extreme values.