Haircut caret



In order to make the caret does not have to go to a salon. Steady hand, sharp scissors, confidence is all you need. Clipper hair must be clean and moist: wash them with good shampoo and conditioner. Divide the head into seven main areas: the left temporal, right temporal, anterior Central (located between the temporal areas), left side of head, right side head, left side of nape, right side of the head. You must first cut the desired length hairstyle.

Traditional Kare ends just below the chin, but may be longer or shorter. Should accesati from a selected zone, the strand is one to three inches wide and cut. The shears during trimming to keep parallel to the floor. Not too to pull the hair: the result should be natural. First, trimmed the front area, then the occipital. In order to make the hair everywhere was the same, you should use a long comb or a ruler. The front Central area of hair (frontal) trimmed last. After the haircut is complete, dry the hair. Use tongs or straighteners to make the hair straight and smooth.

Haircut caret looks neat, elegant and stylish. It is the basis for prolonged, graded, ripped and other types of punishment.

Laying an elongated square with bangs



Before performing styling spray hair various means: thermal protection, hair cream, mousse for hair. You can choose one or the other. Styling starts with a Bang: over the entire length blow it with a Hairdryer. Then curl the Bang to the roots at the round comb. Hold the dryer above the comb. Then lay the back of the hair. Top and bottom hair to separate clip-clip, lay the strands with round brush and Hairdryer. Side areas lay in the same way, twirling them on the comb. The hair is twisted inside. You should move from the bottom strand to the top. To too long strands of spun, use as locking pins or Bobby pins. "Skeletal comb, use for lifting and laying the hair at the roots, creating volume.

Laying graded caret



Graduated caret can be laid also with a round brush and dryer, but the strands should be spinning outward, not inward. You also need to use the pad. So first, apply to clean hair foam along the entire length. Then highlight a small section of hair, and the other remove the hairpin clip. A dedicated strand twist the flat iron upwards and fix it with varnish. The same procedure repeat with each strand on your head. At the end spray the hair with hairspray.