How to install speakers in the "Prior"

In the new Lada Priora native speakers are only available in the maximum configuration. But these cars are not in great demand among buyers due to high cost. In all other cases, set to music in the car you will need.

You will need

• Screwdriver;
• - screws;
• - duct tape;
• - jig saw electric.

Instruction

1. To install speakers in regular places in the doors remove the trim panel. Of the prepared arch, remove the foam end caps which are installed to reduce noise during movement.
2. In the doorway is the OEM wiring harness of the car. Detach the two wires with terminals – large and small. These wires go directly to the radio. Wire terminals connect to the speaker. It has a special output under these terminals.
3. Insert the speaker into the niche and secure it with screws. Put the door trim and screw on caps. In the same way connect the speaker on the other door.
4. Install rear speakers. The wagons or hazakah provides a regular place for speakers with a radius of 13 cm.
5. With the plastic console in the trunk remove the screen under the speaker. Fold the fabric covering the rear pillars. Inside, there are harnesses with wires. From the harness running along the right front, disconnect the two wires with large and small terminals and connect to the right speaker. From the harness running along the left rack, connect the wires to the left speaker. Connection diagram is the same as when installing front speakers
6. Insert the speakers into place and secure them with screws. Top set the grid.
7. Sedan standard seats under the rear speakers are not provided. So you can put speakers of different radius: 13cm, 16cm, 18cm or 6 to 9 ("ovals").
8. Remove the rear cargo shelf. Mark her place under the dynamics. Electric jigsaw to cut out the holes according to the planned lines.
9. Under the skin the rear pillars, locate the harnesses with the standard wiring. From the harness running along the right front, disconnect the two wires with large and small terminals and connect to the right speaker. From the harness running along the left rack, connect the wires to the left speaker.
10. Install the speakers in a prepared niche and secure them with screws.