How to remove alarm

Modern technologies allow to protect your car as possible. Car alarm of the latest generation have a high degree of protection from read codes, all the necessary functions for ease of use. To put this alarm on any machine, after dismantling the old security system.

You will need

• Side
• Screwdriver
• Duct tape
• Tester or continuity test

Instruction

1. Look on the dashboard led. From it must go the wire to the alarm unit.
2. From the alarm unit disconnect the connector with the wires. Each wire coming from the connector, remove the OEM wiring of the vehicle. As a rule, the wire or twisted tape, or soldered. The wires are the connections for the turn signals, Parking lights, limit switches doors, hood, trunk, blocking the engine.
3. The most important thing when removing the alarm and disable lock of the engine. Disconnect each harness from the alarm unit at a time, you'll find the lock. Usually it is rasskazany regular wire. This wire needs to connect to the starting position. After you have the wire connected, start the car. If it would not start, so the wire was not found or that there are lock. Usually lock ignition, starter, fuel pump.
4. Remove the shock sensor or volume. He may be under a plastic flap under the hand brake lever.
5. Remove the Valet button. The location you were supposed to show when you set the alarm.
6. Disassemble the siren in the hood. Unscrew the fasteners and remove the wires leading from the salon.