How to build a catamaran

A trip on the water gives a lot of positives, but it was even more enjoyable and exciting if you go on the catamaran, which was built with his own hands on the advice of experts.

You will need

• Runduce partitions, covers, hinges, scuppers, deck section, recessor, motor, podmoscovye pillers, face shields, dinislamova paneling, foam filler, steel, fiberglass, plywood, paint.

Instruction

1. Glue the two side runduce section.
2. The lids attach special of the loop in order not to lose them.
3. Equip the lockers with scuppers.
4. Prepare for deck section special box – recessor. It will be the motor.
5. Perform cutting work parts vertical main section, which is attached to be brands.
6. Install podrachivala of pillers, medium frames, end shields.
7. Attach gamelobby trim, equipped with foam filler.
8. Fabricate the tube for support. To do this, take your chosen as a support tube, glue it with several layers of fiberglass. Saw through the tube along so that it was easy to remove the layout from the pipe. Put it on again, but the cut was a strip of polyethylene. Then where you want to locate and palate top four layers of fiberglass.
9. Prepare the foam bookmarks and attach them to a top brand.
10. Plywood thickness 10 millimeters fabricate reinforced tabs that will be used on the top brand at the ends and on front inclined part.
11. Attach the upper front plate on the front stinger, reinforced Central cushion and the side plates. Then, the sheet attach to the frames and pillers.
12. Carefully sachette and paint in your chosen color. With the help of foam, run the gain on the transom and fairing. Glue all the fiberglass in one layer, and the bottom two layers.
13. Leave on the assembled catamaran place to place.