You will need
- interior details of the car;
- - carbon fiber fabric;
- - epoxy resin for the base layer;
- epoxy for finish coat;
- - hardener;
- Polish;
- - two pairs of latex gloves;
- - two cups for mixing;
- - two sticks for mixing;
- - two brushes with a width of 2 cm;
- grinding paper 120, 240, 400, 800, 1200;
- - instructions for use of the kit to cover the carbon fiber;
- - room thermometer;
- tape or unnecessary matter;
- - screwdrivers;
- - scales accurate to one gram;
- - scissors;
- home or building dryer;
- - soft non-woven cloth.
Instruction
1
Cover the working place with tape or unnecessary matter. Make sure the room temperature is below 25 degrees. Carefully loosen and remove the latches with a plastic interior (dashboard, door panels, dashboard, etc.).
2
Preparing the item to the wrapping, remove dust, grease and other contaminants. For stable adhesion and making the adhesion oshkurte the surface with sandpaper 120-grit. Remove dust by washing the product with water and wiping with a dry, lint-free cloth.
3
Connect with hardener resin black. Thoroughly mix the components according to the instructions, measuring their number on the scales. Brush on a base coat to the entire surface of the part. Wait four hours, after which the resin dries, becoming slightly sticky.
4
Cut a piece of carbon fiber, fully covering the surface. Attach it to the center of the part and gently, with light pressure, smooth out to the sides. Make sure that the fabric fits tight and does not form cavities and folds, and the base layer is not leaked through the fibers of the material. Carefully trim the excess carbon and tuck the edges under the item.
5
Proportioning, mix the clear resin with the hardener. Brush a smooth, thin layer, lightly impregnated carbon. If there are small air bubbles, remove them by heating the surface with a Hairdryer. After three hours of drying, cover the product with another layer of transparent resin and leave it for eight hours before full hardening.
6
Treat the item with sandpaper, starting with 120 and reaching in order to 2000 grit using all the skins from the set. That abrasive material is not clogged, periodically moisten it with water. Achieving a perfectly smooth surface, bring it to a gloss Polish and a soft non-woven cloth.