You will need
  • To buy a suitable amplifier of appropriate power, dynamics and a set of power and speaker cables. Power cable with a diameter of 8mm are ideal for power amplifier 4x50w and 15mm for amplifier 4х100Вт. Speaker cables should be at least 2x1,5mm, in addition, you will need a fuse rated for currents up to 60A and the holder for it should also have a linear wire and a control wire.
Instruction
1
Standard wiring can not be removed, it does not interfere, it is necessary to cancel the card it will come in handy for other purposes, for example, to connect stop lamp, additional turn signals. Disabling regular acoustic wiring, proceed to pull the new speaker wire. To tighten in the door, use thin steel wire. The wire preferably tighten inside the regular corrugations. So it won't be noticeable that the machine was doing something, and on the other hand, the manufacturer took care of the path layout of the wire harness. Tightened the door wire need to be fixed the same way as was secured regular wire, then it will last a very long time. Inside the cabin of the car, acoustic wire is preferably laid in a single wiring General wiring. Finished one door, you can put a speaker on the prepared place and plug in the appropriate polarity.
2
Standard wiring can not be removed, it does not interfere. It is necessary to cancel the card it will come in handy for other purposes, for example, to connect stop lamp, additional turn signals. Disabling regular acoustic wiring, proceed to pull the new speaker wire. To tighten in the door, use thin steel wire. The wire preferably tighten inside the regular corrugations. So it won't be noticeable that the machine was doing something, and on the other hand, the manufacturer took care of the path layout of the wire harness. Tightened the door wire need to be fixed the same way as was secured regular wire, then it will last a very long time. Inside the cabin of the car, acoustic wire is preferably laid in a single wiring General wiring. Finished one door, you can put a speaker on the prepared place and plug in the appropriate polarity.
3
Remove the front seat, placed under a Mat, a sheet of plywood 10mm thick. It will be attached to the amplifier using the screws. Putting an amplifier on his future place, put the seat back and try to when moving the seat, it did not touch the amplifier.
4
If all goes well, proceed to the output power of the power wire to the amplifier in the engine compartment. For this purpose in the front wall of the body of the drill 16 mm hole and insert the rubber ring with the hole for the wire. Threading wire and pull it to the positive battery terminal.
5
Attach along the entire length to the wiring harness or using clips for attaching wire to the body and connected to the positive battery terminal. Near the terminals, it is necessary to install the power fuse that will save the machine in case of short circuit at the other end of the wire.
6
Output positive power wire to the power block of the amplifier and plug it in. Next, connect the power negative. In contrast to power plus, it is not necessary to pull so far. It is sufficient to connect the vehicle body with the bolt M6 at the nearest convenient place and do not forget to clean off the contact paint, and that it is a good insulator.
7
When the wire is attached to the body, the head of the bolt from the street must be covered with a layer of sealant.
Now, plug the speaker wires according to the diagram, drawn on the acoustic block and plug-in Manager and line wires. Connecting them to the unit, check the how it works custom amplifier and put the seat in place.