You will need
- - adhesive tape;
- - scissors;
- roulette;
- soft cloth;
- - enamel;
- - white spirit;
- film p/E.
Instruction
1
Decorate the refrigerator with a self-adhesive film. The choice of material in the store please note that the film is sold in rolls of different widths. So, make measurements of your fridgeand to reduce cash expenditures, reduce the waste of the film and not to do joints on visible locations.
2
Remove from refrigeratorand all the stickers, Unscrew the handle. Wash surface with sponge and detergent.
3
Cut parts from the adhesive on the removed size, putting them on a paper lined the back side. Don't forget to make allowances for bending the film so that it was possible to tuck under the gasket on the door.
4
Raspleskajte water from a flower spray to the place that you want to paste. Separate the film from the paper layer and apply adhesive to the refrigerator, do not forget to leave allowances.
5
Gradually unroll the film on the surface. Smooth soft cloth, making the movement of "Christmas tree" from the middle to the edges. Expel the air and drops of water. Casual bubble pierce with a needle and smooth cloth.
6
Fold the allowances. In the corners of the adhesive make cuts. Slide the gasket and under it to get the edges of the film. Smooth all cloth.
7
Screw into place the handle of the refrigerator.
8
Paint the refrigerator. Before starting work, protect surrounding objects from falling paint. To do this, tighten them with plastic wrap or cover with newspaper, securing them with tape.
9
Remove from the fridgeand a pen or leave her so she merged with the color of the entire painted surface.
10
Pick up in store enamel of a suitable color. To work is also suitable to spray paint that can be used for metal surfaces.
11
Wipe refrigerator with white spirit. If the surface of the refrigeratorand there are areas with rust, posturite their fine-grained sandpaper. Then a coat of automotive putty and let dry. Again grind.
12
Evenly spray the spray paint over the entire surface of the refrigerator. Let it dry thoroughly and put the updated Assembly in place.