You will need
- - remote control alarm system;
- - the user manual for car alarm.
Instruction
1
Take the manual, review all sections. There certainly you will be able to find a description disable this function. If this information is not there or for some reason can't use a guide, it does not matter. And despite the fact that the process of disabling Valet mode is individual, however, all security systems there is a similar procedure, during which it is possible to disconnect this function. But it is worth noting that it will take a little more time than if you produced this operation manual.
2
First, sit in your car and turn the ignition on, then after 5 seconds turn it off. At the same time try to keep this time interval as in case of failure you will have to repeat the process. Next, press and hold for 10 seconds the Valet switch. This switch can be detected at a signal receiver, which is usually located below the steering column of the machine.
3
Please note, after these steps, the siren of the security system must submit a two to five short signals. After that, a light-emitting diode goes out and the tail lights of the car will flash a few times. After this service the Valet mode will be disabled and alarm will work normally.
4
Make sure before you disable this mode on the control panel there are buttons and switches. If you can't find them, chances are they labelled differently. Then you will have to contact the service center for advice.
5
Use alternative lifting mode Valet. This can be done remotely using the remote management security. For this you need to get in the car, ignition on and turn it off after 5 seconds. Then click the button with the image dynamics and the open padlock and keep them for 15 seconds. The siren will emit two to five signals a few times will flash the Parking lights of the car, and the LED alarm will turn off.