How to arrange jeans

Rested in the summer, visiting your grandmother, you were surprised to find that all the jeans in the closet during this time has been reduced by at least size. And the vacation just ended and money is expected not earlier than in a month. Do not panic. You can increase your jeans and turn them into original model.

You will need

• Jeans, scissors, lace ribbon, needle, thread, sewing machine.

Instruction

1. First, find out which width you need to place jeans. To do this, measure the circumference of your hips at the widest point using a measuring tape. Measurement line passes back through the most convex part of the buttocks and sides through the widest part of the hips. Try not to pull the tape. To the result add another couple of inches for loose fit, a zip up jeans lying.
2. In the absence of the tape measure, use any stretch-free tape and a ruler. Wrap the strip around the hips, select or trim the excess. And then measure the length of the braid.
3. Next, determine the width of the jeans. To do this, lay them on the floor, the front part up. Find the widest part, measure it with measuring tape or long ruler. Multiply the result by two.
4. Now subtract the result of measurement hips measurement result jeans. The resulting difference, and you need to fill. Based on this difference to determine the width of the lace braid. To do this, divide the found the missing value by two and add 2-3 cm (an increase on the seams).
5. Prepare jeans. To do this, first cut the upper stitches of all the loops, and then a fight back zone. Next embroidered lower hem and strut side seams of the pant leg.
6. Cut two pieces of lace ribbon equal in length to the height of the product. Vsheyte them in the side seams. To do this, turn the jeans inside out. Attach with pins or tacking the edge of the tape to one side of the open side seam prostrochite. The second edge strip respectively connect to the second side of the joint. Similarly treat the second leg.
7. Make the bottom cuts of jeans. Select one of the following: - fold back the edge and prostrochite;- sew lace along the cuts:- restrepia lower edge, why pull a few cross threads.
8. Treat the top edge of the pants. The free ends of the belt loops fold down and pristrochite. As a result, the bottom seams of the belt loops will be the top. The upper section is possible as the bottom, to deconstruct or to cover with lace.
9. Since the belt button is no more, sew carefully at the top of the zipper hidden hook and loop.
10. To complete the look, instead of priderite belt in the belt loops of lace ribbon and tie a bow.