How to increase the power of a vacuum cleaner

Sometimes there are situations when a vacuum cleaner can not cope with its task when cleaning the house. Do not rush immediately to go to the service or to call the master. This problem can be solved independently.

You will need

• vacuum cleaner;
• filters;
• water;
• - the trash.

Instruction

1. How to increase the power of the vacuum cleaner for better suction of debris and dust from the Palace? Do one good thing - the view of the filtering system of your vacuum. It can be clogged and so the vacuum cleaner loses power suction. The first filter in a filtration system is a bag, which is a major barrier to dust entering the vacuum cleaner with the air flow. Open the lid of the dust container (usually on the latch) pull out the bag, who is going to the trash, empty its contents in the trash and well knock the dust collector. After that check for integrity; if no holes, then insert it back, the bag does not press down to the hole that leads to the motor of the vacuum cleaner. Disposable paper bag throw them away and insert a new one.
2. The second filter, which serves to protect the motor from accidental dust, is in front of the motor. Regularly check it but not as often as the bag. To check the second cleaner remove the bag and pull out the filter located in front of the hole of the engine, pulling up. Cleaning of this equipment will allow to increase the capacity of the vacuum cleaner.
3. If you don't have an expensive vacuum cleaner, then it should stand flat microfiber filter made of pressed material or of foam; if it's broken, find a similar material and cut with scissors the same detail. On more expensive units can stand HEPA filters that are washable. If you like this, then take the filter and wash it under warm running water, then dry and install it back. Don't forget to check the filter for holes. More expensive filters is coal. They are the most practical and reliable. They also need to washed, dried and set in place in the cleaner.
4. The last filter in the purification system is located after the motor on the air outlet of the vacuum cleaner - he picks up the coal dust from the brushes of the motor. This filter final cleaning less than all affect power, but still makes a contribution in the complete clogging debris. At the exit of the jet of air from the cleaner should stand cover - remove it and under it locate and remove the filter, they are usually made from a sheet of filter material tokenized FST 0001. If it is clogged and painted in black dust from motor brushes, it is better to replace it. Search the parts stores the same material or pick up similar in size to the old filter, cut a new one, then install it under cover. It should be noted - that such filters are used not only in a simple vacuum, but in besmellah cleanerx cleanerx with Aqua.