How to knit a placket for the buttons

For the appearance of the knitted products it is very important how well made clasp. Slats must be given serious consideration. They should be performed smoothly and neatly, do not pull the product and not to form too large of holes in junctions with the main item. This is especially important for products related to free viscous of thick soft yarn.

You will need

• - yarn, which is associated with the product, or finishing;
• - the spokes on the thickness of the yarn.

Instruction

1. The bar for the buttons can be done in several ways. If you knit on the machine of a thin thread to make it visible. For the product associated to the spokes, tie bar directly to the part or even do it in one sheet with the front. In the first case the image will be located in the transverse direction, the second — the same as on the main details. Often used the first option.
2. To perform a cross bar type of the edge the desired amount of loops. This is a very important point. The amount is determined on the eye, but loops should be neither too little nor too much. Strap think about this before you start knitting the parts to which it is attached. The edge loop in this case it is better not to remove, and knit across the row to the junction turned out to be supple.
3. Attach the thread to the beginning of the joint. Guide the needle under the edge loop, capturing both its edges. Pull the working thread. From the same edge if necessary, enter another loop. How many loops to pull from each — depends on the density of the knit and the thickness of the thread. For the product that fit from soft, thick yarn can be a single loop. If you use needles a size smaller than the rest of the parts, dial two. There may be other schemes: three or four edge pull 1 loop, next pass. In any case, see what scheme is right for your product.
4. Think in advance about the picture, which you will knit the bar. It should look good with the basic pattern and at the same time be sufficiently dense. Tie bar front or purl stitch, garter viscous, double elastic. Other types of rubbers are not suitable because they are either tightening the border, or stretch themselves and look messy.
5. The bar can be done single or double. The first option is suitable for very dense knit of thick thread, double strap would look too rude. In this case, the tie strip of the required width and close the loop. When performing the second variant mark the beginning of crease line bundle of a different color. If you knit the bar front surface, the range at which it will bend, tie so that the front side was the wrong loop. Second half of strap tie front stitch. Free edge of tie to edge loops or sew the knitted stitch.
6. For a bracket with a hole type of loop is exactly the same as in the previous case. Davaite her to the line where you will be located of the hole. On cross strap more convenient to do the vertical loop. To do this, equally spaced, close a few loops, and in the next row above the closed type as much. Then knit the same as the bar without a hole to the bend. Mark this line. Provarite several rows, fold the strap on the fold line and try. Make and on the bending of the hinge holes. Calculate them so that when bending the planks they were directly opposite the existing hole. Loops for buttons it will be possible to tie a hook or neaten the same thread.
7. Sometimes strap fit one part with the product. It can also be double or single. At the beginning of the knitting of the dial loops as much as is required for the main details for the external and internal sides of the strips. In this case it is more convenient to knit a strip of garter viscous or purl stitch (if picture is mostly fit face). Hole for buttons easier to do horizontal. Dawasa to the desired height, close some of the loops means having outer and inner sides of the strips, and in the next row of loops the same type. Make holes at equal distances from each other.