You will need
- 4 metal area;
- 2 metal plates with holes;
- The 4 long bolts;
- 16 nuts;
- The thread of wool or cloth;
- Keys for nuts;
- Paint (acrylic);
- Varnish.
Instruction
1
Fasten the nut onto the bolt. Please note that the length of the bolt determines the size of the machine: for this reason it is important to find longer details. Slide the metal plate and area. Take another nut and tighten design.
2
Repeat the same operations with another area. A bit of tilt angles relative to the plates. Subsequently, the work will be much easier. Connect a couple of angles.
3
Insert the bolts and nuts in another pair of corners. Connect the two halves. Check that all parts are held firmly and evenly against each other.
4
Degrease metal machine parts technical alcohol or solvent. Take the acrylic and coat all parts with a thin layer of paint. After 4-5 hours, apply a second layer, then through an equal interval a third. After that, wait for final drying. Apply more thin and transparent layer, so it dried quickly. If desired, apply a thin pattern on some details selectively or to all.
5
Apply two coats of varnish with the same frequency. The first time it should be barely noticeable, only a little gleam. Wait until dry.
6
Wrap the bolt that is located above the horizontal frame, thread or fabric. At work, it will eliminate the sliding filament products.
7
Check the operation of the machine, for example, one of the items that have recently started. Wrap the thread beginning at the protruding bolt.