You will need
- - beech wood or birch;
- - sandpaper;
- - hacksaw;
- - metal rod;
- bolts;
- - wood glue;
- - a piece of cloth.
Instruction
1
Components of the stroller are two frames (large and small), wheels, axles and cradle from a piece of fabric. Start by making strips for frames. The thickness of each of the strips should be 1 cm, width – 1.7 cm, Use a durable beech or birch.
2
Round the ends of the rails with a file, grind them together with the faces with sandpaper. Drill holes in the rails: for the axles, the handle, the slats of the back and in the joints of the two frames. Smoothen the edges of the holes.
3
Make one bar for large and small frames. The diameter of the crossbar is 1.4 cm, Length of the projection on the end of the crossbar is equal to the thickness of the strips. If you can't find for the manufacture of rails round rails, make the rails of rectangular or square shape and grind the corners with a knife, rasp or plane.
4
Insert the crossbar into the holes of the strips and glue. Secure the frame with screws, wintu them to the crossbar of the frame of a smaller size through the apertures of the rails of the frame larger. Make sure that the frame is thus easily rotate relative to each other.
5
Insert into bottom holes of the slats axis of thick metal rod, round rod or solid wood. From the outside slide the washers and attach the wheels. They can be made from metal cans of candy or canned food. Inside of each jar place the wooden disk and nail.
6
In the resulting Assembly drill a hole under the axle and assemble the design, brushing glue cut the inner wooden liner and the axis on which will be the wheel. Close the jar lid.
7
Cradle of stitch the lengths of fabric. Fold the cut for part of the seat around the edges and stitch the lip. Insert the bar inside of thin plywood to make the seat stiffness. The limb of the longitudinal cut will provide buttons with which the cradle will be attached to the beams and frames.