How to knit a hat boy knitting

Beanie, knitted for the baby must be comfortable, beautiful and soft. To do this, try to use a yarn which includes acrylic or cotton. Knit beanie for a boy with a visor and ears. In this product any baby will feel comfortable in any wind and frost.

You will need

• yarn - acrylic 100 %;
• - knitting needles No. 3.

Instruction

1. First tie visor beanie. To do this, take the needles, dial 37 loops and pass one row of the facial. Then promazyvaya rows of garter viscous, in every second row at the end and the beginning of take 1 loop. Continue until, until the spokes will not remain 25 loops. Provarite these loops and tear off a thread.
2. Next, make 2 ears. Start with strings. Dial on needle 3 loops and go garter viscous 18-20 cm Then knit next row: 1 front, 1 loop of the double broach, 1 facial. Then tie a row of facial loops. The third row follow: 1 front, 1 loop of the drive, then the front surface to the last loop, 1 loop of broach and finish 1 facial. Add on loop until, until the spoke will not 17 loops. Next, go 6 cm garter viscous. Thread cut.
3. Start knitting the base cap. Dial on the spokes 13 of the loops, then throw the front loop of the first tab again, type 8 loops. Then provarite loop visor: 2 facial together 12 times, 1 facial, dial 8 loops and promazyvaya the front loop of the second ear, again throw with 13 loops. You should get 69 loops. Go 4 rows front stitch. In the next row, add the reverse loop through a single, end purl 2. When you provarite this number should be 126 loops. Then knit the pattern: purl 2 loops, 2 front. Follow this pattern of 16 rows. Knit next row: purl 2 together (2 front, purl 2 together). Get 94 loop. Then evenly turn down 2 loops.
4. Start to crochet through the top. First row: (11 front, 2 at the front) 7 times, finish with 1 facial. Next row purl stitch walk. Third row: (10 facial, 2 facial together) 7 times and 1 facial. Fourth row - purl loops. Fifth row: (9 facial, 2 facial together) 7 times, 1 facial. Next, take away 7 loops in each odd row up until the spokes will not remain 15 loops. Tear off the thread and pull loop. Then thread the well secure.
5. The back of the cap make a seam. Sew the sides of the visor together with the main part of the beanie. Make a small pompom and attach it in the center of the product.