How to extend gel nails on tips

Naroscheny nails look impressive and give the hands a well-groomed appearance. Modern technologies allow to dream, creating an unusual design and shape artificial nails. Women need only to choose the method of building.

You will need

• disinfecting solution;
• - pusher;
• - nail nippers;
• - buff;
• - sawing;
• - tips;
• - pliers to cut tips;
• glue for artificial fingernails;
• - primer;
• boat;
• brush for applying the gel;
• gel;
• - ultraviolet lamp;
• wipes with special solution;
• - lanolin oil

Instruction

1. One of the main ways of creation of artificial nails is a method of extending to tips. Starting to build-up, wash your hands or clean them with disinfectant spray. Gently move the cuticle pusher. Trim the nails through the upper hole of the nail and erode a nail file. Remove the top cover of the nail, use a hard nail file. Proper preparation of the nail plate will grow lengthen eliminate the exfoliation of the material from the natural nail.
2. Pick up the material so that the bonding boundary of the hole was not below one-third the length of the natural nail. For clients whose nail plates short, fit tips with a narrow hole. The width of the material choose so that the natural nail is completely covered from one corner to the other.
3. The selection of material should take into account the convexity of the natural nail. On a flat, glue flat tips because convex will depart, forming an air pocket. The adhesion of the material to make one drop of glue that should be applied to the hole tips.
4. Next, decide on the desired length and shape of the artificial nail. Using pliers, trim the material to the desired length. To soften the seam between the natural and artificial nail filing, it is recommended to use special liquid.
5. Now give the file the necessary form to the artificial nail and sawed it. Sand the seam with a nail file or buff without touching the natural nail.
6. Grind the blade material along the entire length up to the complete disappearance of the luster. Over the entire nail special podgotovitel and wait until it is completely dry. Then miss the nail primer. A special brush, apply a thin layer over the entire surface of the natural nail. Place your finger in the UV lamp for one minute, and then apply a second coat of the gel more tightly along the entire length of the nail. Again, put the nail in the UV lamp for two minutes.
7. Remove sticky layer with special wipes. Apply lanolin oil on the cuticles and gently RUB it. The nail is ready.