You will need
- - a large sheet of paper;
- - pattern-based trousers;
- pencil;
- - the range;
- - a pair of scissors.
Instruction
1
To build the pattern of the shorts, you need to create pattern-based classic women's trousers. The instructions on how to build it, http://www.kakprosto.ru/kak-91888-kak-postroit-vykroyku-klassicheskih-bryuk. After she is ready, you can start modeling for future shorts.
2
Measure the length of the product. It may vary from knee length to mid thigh. The waist line was lower by 3-5 cm
3
Mark the line of the pocket on front part. Draw a diagonal line, departing 3 cm from the lateral line towards the middle and 12-15 cm down.
4
If you wish your shorts were a little flared and a free draw from the Darts in a straight line. Cut the part along this line and spread, and the point on the waist line must be aligned.
5
Build the detail of the burlap pocket. Attach a sheet of paper detail of the front and circle line entrance to the pocket. Step back from the top 2 cm to the side and from the lower 6-7 cm to the side and 2-3 cm down. These points connect smooth lines.
6
Make pattern belt and belt loops. The pattern of loops is a rectangle 3x5 cm zone is a rectangle with its length equal to the circumference of waist plus 6 cm and a width of 6 cm Width of the finished belt will be 2 see If you want to carve out a wider zone, respectively, increase the width of the part. It should equal the desired width of the belt multiplied by 2, plus 2cm for allowances.
7
Paper pattern shorts ready. Put her on the wrong side of the fabric and draw a chalk. All parts are cut out, leaving allowances for seams at 1 cm on the side of cut and the waist line. For bended form the bottom, leave 3-4 cm belt Detail and belt loops cut out without allowances (they are built into the pattern).
8
Burlap pocket will have plenty of lining fabric, and the area of the side seam above the entrance to the pocket from the main.