You will need
- A constant current source (vehicle battery). Resistor, supplied with the condenser or a 12V light bulb if it is not.
- Wires for connecting the capacitor of the same section, and wires for power connection.
Instruction
1
Make sure that:
terminal of the capacitor " + " connected to the power wire of the amplifier;
terminal of the capacitor " - " is connected not to the amplifier and to ground of the car.
terminal of the capacitor " + " connected to the power wire of the amplifier;
terminal of the capacitor " - " is connected not to the amplifier and to ground of the car.
2
Gently remove the audio fuse.
Disconnect the wire from the terminals of your capacitor is marked with "+"
Connect your power source to the network (we have a car battery).
Connect the supplied capacitor resistor one terminal to the capacitor terminal marked "+".
Repeat the above step, if you connect it through a 12V light bulb.
The other contact "-" connect to the power cord.
Repeat the above step, if you connect it through a 12V light bulb.
Disconnect the wire from the terminals of your capacitor is marked with "+"
Connect your power source to the network (we have a car battery).
Connect the supplied capacitor resistor one terminal to the capacitor terminal marked "+".
Repeat the above step, if you connect it through a 12V light bulb.
The other contact "-" connect to the power cord.
Repeat the above step, if you connect it through a 12V light bulb.
3
Reconnect the audio fuse.
Wait at least two minutes, after which the resistor is required to disconnect, and the wire feeding the capacitor, to connect to "+" terminal directly.
When connecting through a resistor, the charging time of a capacitor determine its technical documentation.
Wait at least two minutes, after which the resistor is required to disconnect, and the wire feeding the capacitor, to connect to "+" terminal directly.
When connecting through a resistor, the charging time of a capacitor determine its technical documentation.
Note
Do not tighten the clamps very tight.
Do not use the condenser from mechanical damage.
Do not use the condenser from mechanical damage.
Useful advice
When connected via the light bulb the charging process of the capacitor becomes more obvious.
While charging through the bulb, it should light. After the light gradually goes out, this will be the signal that the capacitor is fully charged.
While charging through the bulb, it should light. After the light gradually goes out, this will be the signal that the capacitor is fully charged.
