You will need
- - car KAMAZ,
- - the fuel high-pressure pump,
- - metal rod with a diameter of 10 mm, a length of 30-40 cm,
- spanner, 17 mm.
Instruction
1
Despite the simplicity of the design of the diesel engine, components of its fuel injection equipment are high-precision instruments, and while the injection pump mount V-shaped type on the motor requires excellent determine the angle of injection timing, injector of diesel fuel to the working cylinder on the compression stroke. Error price of one degree can cause the output of the power unit from the system and entail the holding of major repair.
2
Technology installation of the fuel high-pressure pump with simultaneous installation angle of the injection timing is the following sequence of actions:
raise the cab and lock the latch into a supporting stand
on the left side of the engine, on top, in back, look on the casing of the casing of a flywheel is a mechanical device, the stock of which is necessary to lift and rotate 90 degrees, and then lowered into the housing slot;
- from the bottom of the machine casing flywheel key 17 mm remove the two bolts and remove the splash shield;
- insert the metal rod through the slot of the casing in the hole of the flywheel and rotate the engine crankshaft from left to right as long as the stock retainer on top will not block its further movement;
- check the position of the drive shaft of the fuel pump, located in the collapse of the engine block (top);
in the case where the drive coupler fuel pump setup turned the dial up, then align the zero mark of the drive with the notch on the flange of the fuel pump and tighten the two mounting bolts;
otherwise, the stopper is raised, and the crankshaft of the engine rotates for one turn, and then re-execute the above steps.
raise the cab and lock the latch into a supporting stand
on the left side of the engine, on top, in back, look on the casing of the casing of a flywheel is a mechanical device, the stock of which is necessary to lift and rotate 90 degrees, and then lowered into the housing slot;
- from the bottom of the machine casing flywheel key 17 mm remove the two bolts and remove the splash shield;
- insert the metal rod through the slot of the casing in the hole of the flywheel and rotate the engine crankshaft from left to right as long as the stock retainer on top will not block its further movement;
- check the position of the drive shaft of the fuel pump, located in the collapse of the engine block (top);
in the case where the drive coupler fuel pump setup turned the dial up, then align the zero mark of the drive with the notch on the flange of the fuel pump and tighten the two mounting bolts;
otherwise, the stopper is raised, and the crankshaft of the engine rotates for one turn, and then re-execute the above steps.
3
After tightening of the bolts drive coupling flange injection pump, lock the flywheel goes up, turns 90 degrees and descends in the groove. At the bottom of the flywheel housing is installed the splash shield. After that, the cab of the truck is lowered, the clamps are raised to the upper position.
