How to make a machine for living water

Many machines can be done at home with your own hands. For example, you can make the device for the preparation of live and dead water. Living water is considered water, charged with positive charge, dead negative. Drink the living water promotes rejuvenation and cleansing of the body.

You will need

• Two plates of stainless steel, of a width 5 cm, length 15 cm.
• A semiconductor diode.
• Plastic case with detachable cap long 20 cm
• The plug wire.
• Two cans of water.
• Wire.
• Screws.

Instruction

1. Attach two stainless steel plates to the plastic housing. For this slot in the bottom of two parallel cracks, which can pass plates. Slits should be in opposite ends of the plastic housing. Then insert the plate into the slot and secure them with screws.
2. Place the plastic housing of a semiconductor diode and connect it to the stainless steel plates using wires. Note on the plates from the outside, where the "minus" and where "plus".
3. Make in plastic casing the hole for the wire with the socket. Insert the wire and attach it to the semiconductor diode. Close the housing cover.
4. Fill 2 cans with water. Put them side by side. Dip the apparatus for making a living and dead water in the jars so that each of the electrodes (plates) was in a separate Bank. Turn the device on and leave it on for 10 minutes.
5. Disconnect from the network. Take it out of the cans. Discard "dead" water to drink "live".