You will need
  • - wooden frames;
  • rail;
  • - fasteners;
  • - the mitre box;
  • - hacksaw or jigsaw;
  • - colorless sealant;
  • - sandpaper;
  • - PVA glue joiner;
  • - furniture stapler.
Instruction
1
Draw on paper a sketch of the future frame for a mirror. Consider whether you want to decorate it, for example, moulded with flowers from polymer clay, seashells, buttons, feathers, fabric, tile or just paint lacquer. In the latter case, it is best to stop the choice on the corrugated casing with a beautiful structure of wood, so she looked through and was emphasized with a clear coating.
2
Remove the dimensions with the mirror blade and decide how many pieces of trim and rails you need to purchase. Put the dimensions of the frame on the frames and place pieces of wood into the mitre box. Make the cut at an angle of 45 degrees, to allow them to dock at a right angle. Treat wood slices coarse sandpaper.
3
To fix mirror in a frame in several ways

The first option. Mark with a pencil on the side of the architraves the thickness of the mirror and on the reverse side of the depth at which the mirror comes into the frame. Using a hammer and chisel out the grooves. Where you want to locate them.
4
The second option. To saw the slats so that they can be glued on the inside of the frames. Guided by the pencil line, which corresponds to the depth setting of the mirror into the frame, put slats on wood or PVA glue "Moment Crystal".
5
Assemble frame. Fasten it on the inner side brackets from a furniture stapler. Then make the parts from plywood and screw them to the frame corners with screws.
6
Decorate the frame. Scuff the entire surface of casings fine-grained sandpaper. Now you can cover the frame with varnish or paint. It is advisable to do this on both sides, to better protect the tree.
7
Swipe colorless silicone sealant around hollowed-out grooves or at the junction of the rack and frame. Insert the mirror and gently push it so it is firmly entrenched in the frame.
8
Make a fixture that the mirror can be hung on the wall. Saw out of plywood, two small rectangle. Fasten them with screws or screw in small hooks on the back side of the frame. Therefore, you are safer to mount the mirror and will make the basis to which is attached a rope.