You will need
  • - cotton gloves;
  • - Phillips screwdriver.
Instruction
1
Turn the transmission into neutral and lock the vehicle with the Parking brake. Turn off the ignition and remove the keys from the lock. Open the hood and disconnect the "minus" terminal connector from the battery to prevent short circuit. To replace the best in the garage. If not, it will fit anywhere under the canopy.
2
Purchase a set of new light elements. Use light bulbs of only the firm that is recommended by the manufacturer. Installation of light elements from a third-party manufacturer is not recommended, as in this case, you run the risk of the technical condition of your machine.
3
Locate the black plug from rubber, which gives access to the main beam. Gently unplug it and remove it.
4
Pull the socket wires attached to the lamp, and unplug it.
5
Find the latch holding the springs. Carefully remove it from the slots. Remove the bulb from the connector. Carefully inspect it. If the lamp exploded, it is necessary to carefully remove all debris from the slot.
6
Install the new bulb in the reverse order. In the same way replace the bulb the high beam on the second headlight.
7
Replace light bulbs low beam in both headlights. Proceed on exactly the same principle. The difference will be in the hole for replacement of lamps it is near the hole for replacement of the high beam lights.
8
Unscrew the four screws holding the cover to replace light bulb front turn signal. Disconnect the casing. Grasp the cartridge light bulb and rotate it counterclockwise until it stops. After that, a cartridge with a bulb can be removed.
9
Unscrew the bulb from the socket counterclockwise. Insert a new lighting element and install the cartridge in reverse order. After that, connect the battery terminal and test the new bulbs.