How to glue Vibroplast

First, detach the door trim. You also need to remove the cable handle and the wires that go to the regulator. Now you are ready the door which can cause noise absorbing materials. Remove the plastic wrap, which is provided by the manufacturer.

Next, degrease the surface of the door. Cut Vibroplast pieces and glue them on the inside. It is not necessary to glue the entire inner surface. Tightly roll the material to the surface of the door. Otherwise it will not work correctly, and when heated can fall off. To roll it, use a special roller.

After you have done the inner layer, proceed to the sealing of the factory mounting holes. In the end it should be a loudspeaker enclosed volume. In addition to noise insulation should be better sounding speakers. For sealing mounting holes, also can be used Vibroplast.

Using pencil and paper first to make patterns. On it, you'll be able to cut equal parts of the Vibroplast. Parts should be a few inches larger than the hole. The material in this case can be securely glued to the door. If necessary, glue the whole door. Keep in mind, it will have great weight. When the label material use construction Hairdryer. Heat the material and firmly smooth over the surface.

Similarly make the noise all the doors of the car. If you need, you'll route the speaker wires. In those places where the paneling adjacent to doors, stick Vibroplast. Slice it into thin strips. Do them a width of about 2-3 cm Vibroplast should be in all areas of contact. Reassemble the door in reverse order. If necessary, replace the useless clips on the door trim.