Instruction
1
Determine the location of the device. The standard bar does not provide space for a tachometer. You can use as the basis for torpedo 2107 or make the tachometer as a single instrument. In the second case, you need a case to secure the device to install it on the panel or on the windshield. This case can be purchased in the store or make it yourself from scrap materials.
2
Connect the tachometer. Based on take the unit from car VAZ 2106. It has a male connection. Posting "five does not provide a similar connector, so cut terminal contact, leaving only the conductors. You will also have to increase the wire in order to stretch them to the ignition coil. Connect the wires of the device is as follows: to brown plus the ignition coil, the orange wire attach to the coil terminal that is marked "B+ , black and white wire attached to the car body.
3
Install electronic tachometer. This tachometer can be put anywhere in the car. This is one of advantages over conventional apparatus. It has three wires that go to the coil ground terminal of the coil. The transducer has a marking of conductors.
4
Place a torpedo from 2107. This step is a more exotic way when you install a tachometer. Remove the instrument cluster of the five by removing side screws. Disconnect all the chips. Next remove the nuts that attach the dashboard to the vehicle body. They are on the rear panel. Then remove the screws that secure the panel on the back. Remove the control knobs of the stove, an ashtray. The new panel is installed the same way. Putting a torpedo 2107, you can connect a dashboard of the same car, which is equipped with a built-in tachometer.