You will need
  • A car with automatic transmission.
Instruction
1
Carefully read through all operating positions, which translates the select lever range (RVD) transmission cars with automatic transmission. They are accompanied by alphabetic and numeric symbols.
2
Remember, in some of these provisions are allowed to start the car. They are usually denoted by the letters P (from the English. parking – Parking) and N (from the English. neutral – neutral).
3
Move the selector lever range in zone P. This condition of the transmission corresponds to the long-term Parking. Controls turned off. The output shaft is blocked. Movement is impossible, but the engine start is permitted.
4
Start the vehicle. The engine will run at idle.
5
Turn the selector to position N. In this case the output shaft is not locked and the car is able to move. For example, it can be towed. Also in this position of the lever range are allowed to start the engine.
6
In any case, before you attempt to start the engine always check the position of the select lever range. Learn what types of positions RVD is invalid if the factory car. This R (from the English. reverse, or reverse). And all (four or more depending on the brand of machine) of the zone moving forward: D, 3, 2 and 1 (L).
7
Trust your own car. As a rule, cars with automatic transmission are equipped with a passive safety system. It does not allow the motorist to start the engine in the other positions of the selector except P or N.
8
Get a car with automatic transmission with tow. Install the selector lever in position N, switch on the ignition and immediately start the tow. To achieve the desired oil pressure in the transmission is cold the car will accelerate to a speed of 30 km/h, heated to 50 km/h. After 2 minutes at the specified speed turn selector switch to mode L or 2. Press on the gas pedal. In order not to overheat the transmission in a few seconds, return the selector switch to position N regardless of, revved or not. Try again, after passing some time in neutral.
9
Similarly, you can start the car, which stands on the hill. Put the lever in position N and push the car downhill. Once she gets enough acceleration, switch the lever to downshift and hit the gas. Return the selector to neutral position regardless of the outcome.