You will need
- - ammonia solution;
- - acetone;
- - turpentine;
- - gasoline;
- - talc;
- soap;
- tea soda;
- - ammonia;
- - formalin;
- - magnesia;
- - water.
Instruction
1
As a rule, to remove the oily stain from the leather using a solution of ammonia, acetone, turpentine or gasoline. But this method is suitable if the skin does not contain nitrobarite.
2
No less effective when dealing with oily stains tea soda. To do this in a glass of warm water dissolve 1 teaspoon teaspoon soda. The resulting solution was thoroughly RUB the desired area until foam. Then remove the stain with a dry cloth. This procedure is repeated until then, until the contamination is completely gone.
3
Also, very often to remove any impurities on the skin use talcum powder mixed to a paste with gasoline. The resulting mixture was put on the contaminated area and leave for 2-3 hours. Once the fat is completely absorbed into the powder, shake off the remnants of the mixture with a brush and wipe the spot with a damp rag.
4
Very good fights with oily stains, the solution of ammonia. To do this, 1 teaspoon of warm water mixed with 1 teaspoon ammonia and 1 teaspoon of soap shavings. By the way, water in this case can be replaced with milk. The resulting consistency wipe the stain until it is removed. The remaining solution, rinse with clean water.
5
If the stain is very strongly absorbed in the leather, you can use the tool on the basis of formaldehyde. For its preparation you will need 1 tablespoon of soap chips, 1 tablespoon of ammonia solution (5%), ? a glass of formalin. These ingredients mix and apply on the oily stain for 1-2 hours. Further, the same solution RUB the soiled area. In the end, wipe everything with warm clean water. If necessary, repeat the procedure.
6
Fat spot light on skin treated with a special paste. For its preparation you will need 1 teaspoon of gasoline, 1 teaspoon of talc, 1 teaspoon milk of magnesia (powder). All the ingredients are thoroughly mix and apply to the contaminated area. After 15-20 minutes, sprinkle on the mixture of the gas and leave it to dry. After this, powder residue, remove with a dry cloth or brush.