Instruction
You will need:
- motor (can be from the player, only with plastic roller);
- wire;
- string (the thinnest);
- gel pen;
- power supply and mount motor (metal clip-holder from the handle).
- motor (can be from the player, only with plastic roller);
- wire;
- string (the thinnest);
- gel pen;
- power supply and mount motor (metal clip-holder from the handle).
Gel pen, Unscrew it and remove the paint. Of the metal rod "pick out" the ball, using a needle. Grind off the tip with a file to fit the string and move freely back and forth.
The tube handles are pruned twice to save the string and the convenience in use. Tube that the paint was cut off, leaving a piece the size of like half of the previous tube. It will restrict the vibration of the string during operation.
The tube handles are pruned twice to save the string and the convenience in use. Tube that the paint was cut off, leaving a piece the size of like half of the previous tube. It will restrict the vibration of the string during operation.
Go to the motor. To attach the motor to the tube, take the metal holder from the handle and just tape the tape to the motor. Make a small hole in the shaft of a motor with a red-hot needle the size of a string (not centered).
Measure out the desired length of the string. Pull it with a pliers and then heated with a lighter in the place where her future sharp tip. She is hot, become thinner and burst. Sharpen the string, using the stone for turning knives. Insert the string so that the tip was peeking out from the rod 4 mm, and the second end of the folded string with the letter G and inserted into the hole in the cushion. Twisted wire mikromotorchika with wires and connected to the power supply.
Useful tips:
To make a tattoo machine at homewith only need 15 – 20 minutes. Before using, need to adjust it in order for the string was tensioned correctly and not beat anywhere. You also need to choose a power supply with adjustable power so you can reduce or increase the speed of the tool.
To make a tattoo machine at homewith only need 15 – 20 minutes. Before using, need to adjust it in order for the string was tensioned correctly and not beat anywhere. You also need to choose a power supply with adjustable power so you can reduce or increase the speed of the tool.
