How to disassemble the mouse

Even the best quality mice tend to become clogged. There are many such small slits, where the needle can barely get through, but dust and hair were placed there with comfort. And sometimes even on this little device so inappropriately spilled coffee. What to do when the mouse is blocked, while the button and wheel do not give the appropriate reaction? Out one, or rather two: you can just throw the mouse, and if it was not in your plans, you will have to disassemble the mouse.

You will need

• A small Phillips screwdriver, a container for storing screws

Instruction

1. Prepare the mouse to disassembly. To do this, disconnect it from the computer and put it on the table, turning upside down. Look on the bottom of the mouse mounting screw. Cogs are sometimes not immediately visible, as they are often hidden under stickers. In this case, first remove the base of the mouse all the stickers.
2. Carefully Unscrew the mounting screws. The screw heads on the arms usually cross shape, so the screwdriver required is the same. The screws are located in recesses, removing them will be easier with a magnetic screwdriver. Important after loosening the screws to put into a container, otherwise they will be lost.
3. Open the case. To do this hold the mouse with two hands over the upper and lower surfaces and pull. Calculate the effort not to disengage the cover latch around the cord. It is best to pull the cover up and slightly to the left. It is now possible to purge and clean the inside of the mouse of accumulated debris and dust.
4. Remove the base of the mouse wheel (scroller). There are different designs of mounts scrollers. Often fairly beat up and the wheel will be removed together with its fastening or latch. Axle wrap-scroller is often a lot of hair. Remove this hair with a suitable tool.
5. Remove the card or mikroshemka mouse. The Board is attached by clamps, or bolted with screws. Latch gently pry off with your fingers. And Unscrew the screws and put the rest of the details. Easy pulling tab up, separate it from the body of the mouse. All, analysis of mouse over.