You will need
- — knitting needles No. 2-2,5-3 (depending on thickness of thread);
- — yarn — 50-60g (colored or plain);
- — needle stitching details
Instruction
1
To start, measure the width, length and height of your phone with a ruler. Suppose that the width of the phone is 4.5 cm, length 9.5 cm, height 2 cm So the total width of case is approximately 6.5 cm and a length of about 11 cm Select the picture you want to knit a case for your phone. This can be as a convex pattern, for example, "spit", and simple facial surface, which can then be sewn on beads, rhinestones or sequins.
2
Associate trial sample, approximately 6х6см to calculate the number of loops. Suppose that the number of loops per 1 cm is equal to two, then to cover the spokes need to score 13 loops. Typing loop, knit in your chosen pattern 11 see If you want your case was with the valve, then need to further knit into 5-6 cm
3
The resulting strip is slightly amperite iron without touching knits the sole of the iron, otherwise the convex pattern may be tapered. Sew the sides of the strip between the folding of the strip inside out. Instead of a needle you can use a hook, in this case, the product does not need to put the right sides inward. Start to tie the case in a circle, starting from the bottom of columns without nakida. Can tie the cover of lush columns with nakida and knit one loop from 3 to 6 lush bars. So the edge of the case will turn out relief. Remove the case.
4
If you've connected the box with a valve, pick a button and link the hook from the center of the valve a chain of air loops to form a loop for the buttons.
Useful advice
To connect the product crochet a simple column without nakida need to connect the edge products. Hook introduce myself through the edge of the loop, grab the working thread, which will connect to the product, and stretch it across the edge loops back to itself. With the following edge loop will do the same.
Now on the hook to form two loops. Throw a working thread on the hook toward you and pull through the loop that was on the hook. Then knit the same way. Upon completion of the work in the loop pull the tip of the working thread and tighten the knot.
Now on the hook to form two loops. Throw a working thread on the hook toward you and pull through the loop that was on the hook. Then knit the same way. Upon completion of the work in the loop pull the tip of the working thread and tighten the knot.