You will need
- -metal kettle;
- -shower hose;
- -steel tube;
- -the burner;
- metal strainer;
- -soldering pin;
- -the file;
- -duct tape;
- -foil.
Instruction
1
Take the usual pot metal – it can be successfully used as a flask. To replace the hose for Smoking try it with a simple shower hose. However, in shops you can buy special hose for hookah, and it costs very cheap.
2
To make mine fit, take up a thirty-degree steel burner for gas stoves as well as conventional metal tea strainers that are bought for installation in the kitchen sink. Take a soldering rod to join metal surfaces together.
3
Take the tube and the burner and try to connect them together so that it was completely sealed. The other end of the tube similarly attach to the lid from the tea infuser. Remove the cover from the handle, drilled the hole to such an extent that its diameter was equal to the diameter of the tube.
4
The tube make two grooves intended for solder, and then shove it into the kettle at a fairly low height. Install the cover back and solder it to the edge of the tube. Then the whole procedure repeats, but already with the back side of the cover. Spike after work thoroughly Polish with a file.
5
Then attach it to the spout the hose from the shower or a hose for hookah. Obviously, this will have to saw off the end of the spout. So stick the hose inside will be much easier. To seal the junction of the hose and kettle, gently wrap it with insulation tape. To the nose pull from the top nut of suitable metal.
6
Make sealed the place where the cover is to lie on the kettle, cover it carefully with foil. After that, the burner, put funnel made out of foil. There will absorb the tobacco. On top of the hotplate place a strainer. Hookah is ready – try to fire it up.
