How to knit a hat for a doll

Think about what hat you want to link. From dolls can be a beret, beanie-stocking cap-helmet with visor or without. Very well, if you have enough of the same yarn to make then a scarf and mittens to match the hat. The child must learn not only the sequence of dressing, but to learn to understand what things are fit to each other and which are not. If a small child, doll hat better to do with strings, so it isn't lost on the street. So knit beanie-type cap.

This cap consists of only one part. It is a rectangle. Its length is the circumference of the face of the doll, and the width - distance from bottom of cheeks to the middle of the back of his head. Greater precision here is not required. If the rectangle will be too wide, it will be possible to make a lapel and decorate it simple with lace. And you can prisborivat the cap by the bottom line.

Start knitting a rectangle with one of the short sides. Dial a chain of air loops. Make a loop on the instep and knit columns without nakida. For doll clothes this is the most convenient form of binding, especially if the doll is small. The image is quite dense and smooth. Clothes for large dolls can be connected in any pattern, including fishnet.

Knit a hat straight at the desired length. Periodically try your creation on the doll. Imagine that you put the doll on the head short scarf, the ends of which should be exactly under the chin.

Ready strip fold in half, aligning short edges. Sew back seam, or close the hook. Shivaite on the wrong side. If you close the seam with a hook, you can make a decorative line. In any case, the following operations are performed on the front side.

To open the corners of the resulting rectangle double tie drawstring. They represent just the laces out of the stitches. However, you can make and the clasp, if these angles are closed right under the chin. Sew one small button, on the other make the air loop.

Hat can be decorated. Tie it with contrasting thread by the same poster. For the little doll that will be enough. On the edge of the big caps can make the teeth.

Make the tassel. Fold the thread several times, tie it on one of the bends. Make the second node at a distance of 0.5 cm from bend, thread covering the whole beam. The free ends exactly cut.. From the corner beanie knit chain of air loops and tie a tassel.