You will need
  • - the air heater;
  • - wall panels;
  • bucket;
  • brush;
  • water;
  • - spatula;
  • - primer;
  • - plumb
  • - drill with drill bits;
  • - screwdriver;
  • - hacksaw;
  • - wood saw;
  • - gon;
  • pencil;
  • - screws;
  • - hammer;
  • roulette;
  • rail;
  • - insulation;
  • - aluminum tape;
  • - special glue.
Instruction
1
Heat up the room, the walls of which are glued wall panels. The minimum temperature of the air is 10 degrees above zero.
2
Unzip wall panels and leave them for a few days in a heated room (remember: temperature must be above ten degrees).
3
Prepare the wall. This operation is performed in two stages. First: remove with a spatula the old Wallpaper before wetting them with water and giving a bit of swell. Second: programsuite wall.
4
If the wall is perfectly smooth, apply a uniform layer of glue on the first wall panel (let it soak), and then on the surface of the walls. Not later than half an hour after applying the adhesive apply the wall panel to the wall, press it gently and flatten (top down and from the center of the panel to its edges). The method of attaching the next panel (joint to joint or overlapping) depends on the recommendations of the manufacturer of wall panels, which are set out in the instructions supplied with the product.
5
If the wall surface is uneven and has lots of damage and defects before gluing wall panels, install the purlins. Remember that the crate should be placed perpendicular to the panels. With screws attach reechki sheathing to the wall. The distance between the grid should be 600 mm: at too great a distance any pressure on a wall panel may damage it. On the non-foiled side of the insulation, apply a thin layer of glue and stick it, and then seal the joints of the insulation with aluminum tape.
6
After that, install framing accessories (angles and profiles) and only then attach the wall panels.