Advice 1: How to adjust the telescopic sight

For effective use in conjunction with optical sight rifle require adjustment, allowing to correlate the distance to the target correction parameters. Zeroing of the sight - the process is quite entertaining, especially for those who loves and appreciates their weapons.
How to adjust the telescopic sight
Instruction
1
After installation of the sight on the rifle, sighting need to start with a distance of 50 meters. Set at this distance, the target and fix the rifle so that with open sight to bring it accurately to the target point.
2
When the adjusting screws place the crosshair of the optical sight is exactly the point at which the induced open sight.
3
Carry out a test shot.
4
Repeat the procedure, removing the target at 100, 200 and 300 meters, recording for each distance the tick marks on the adjustment screws of the sight.
5
If necessary, visually note the difference between the position of the crosshair over a shorter distance and shot at a greater distance. It may be useful in a situation when adjustment of the sight may not be time.

Advice 2 : How to adjust a red dot sight

Today, the market accessories for hunting weapons, a considerable number of scopesused for rifles and shotguns. Special attention among this diversity attracts so-called reflex sight. These types of sighting devices, initially found application in military aircraft, are increasingly popular among hunters. The sighting collimator sight has a number of features.
How to adjust a red dot sight
You will need
  • - hunting weapons;
  • - reflex sight;
  • paper target;
  • vise.
Instruction
1
Refer to principle of operation and device collimator sight. It is an optical system consisting of prisms with the brand (ring and dot), which is projected onto translucent glass. The hunter observes the target through the glass; the point is designed for aiming weapons at a stationary target, and the ring allows you to choose the right pre-emption when shooting at a moving target. This design gives the arrow the ability to quickly take the correct pre-emption and reliably to hit the target.
2
Getting to the sighting collimator sight, keep in mind that the greatest efficiency it has when shooting buckshot at a distance of 35 to 45 m and for precision rifle shooting at long distances such a sighting device may be totally unusable. Zeroing of the sight consists of two manufacturing operations and includes the installation of the sight on the weapon and the actual sighting.
3
Secure the base of the bracket of the sight on the weapon, paying attention to the tightness of the screws and trying to ensure a tight installation. Density mounting of the sight is required to resolve the capturing device when shooting and when removing and installing the sight in case of transporting weapons.
4
Setting the scope, secure the rifle in a vise, equipped with soft plates in the region of the jaws. Move your open sight aiming point attached at a distance of 100 m. as the sighting the target, use is made of a black paper circle with a diameter of 50 mm.
5
Now, looking at the reflex sight, select the centre mark on the aiming point. Use for the installation of flywheels side and remote adjustments. After some time, disconnect the sight and install it again, thereby verifying the absence of the churning of the established scope. The final stage involves shooting and following the final amendment of the location of the aiming mark.
Is the advice useful?
Search