The first is to take care of the place where you will dismantle the bumper. Given that you have to crawl under the front of the vehicle, it is better to find the overpass. Also quite suitable pit in the garage. Place the vehicle in neutral speed and apply the Parking brake. Now you need to put under the front spar and the Jack to raise the car. This is necessary in order to gain access to the fastening of the bumperand which are from the wheel arch. It is best to use two jacks at once, then you do not have to lower and raise each side.
Open the hood and remove the negative terminal from the battery. Wash your wheelhouse, as the fixing can be hidden under a thick layer of dirt. If the garage have a sink, you can wash the arches before the race in the garage. If the sink is far enough away from where you plan to remove the bumper, meaning to wash the car. After cleaning, locate the mounts of the bumper. This can be screws, rivets, or bolts. Gently turn them. If the bumper is attached with screws, it should be very gently and slowly remove them so as not to damage the socket into which they are driven.
Now find the wires leading to the fog lamps. Disconnect the clip. Fog lights themselves are normally attached to the bumper, so there is no need to remove. If the lights attached to the bumperand the beam that holds the bumper, they need to be removed. Open the plugs is best to close anything that they are not clogged dirt. Unscrew all the bolts that connect the bumper and guard. Grasp bumper on both ends and slightly pull it to come out of the main mounts. Now disconnect the electrical wires and hoses going to the headlight washers. After that, the bumper can be removed completely. Keep it symmetrical, otherwise it may break. Installation is performed in reverse order.