You will need
- - thin Phillips or a flathead screwdriver.
Instruction
1
Remove the battery. Unscrew the rear part of the stick with a Phillips screwdriver of small size. You need to Unscrew 6 screws that are on the panel, and one screw located under the sticker in the slot for the battery. Put the screws so that not to lose them.
2
Carefully remove both covers of the joystick and remove the chip. Remove the top panel (which are triggers) and the lower plastic part of grey. Gum on the buttons don't remove.
3
Unscrew the d-pad controller, which is fastened by 2 screws and is clipped. First, twist the screws and only after that try to release the metal clips with the same screwdriver. Then you can push the d-pad.
4
Remove the elastics from the buttons. To remove the side trigger, release it from the plastic part that is inserted in a corresponding groove of the button mechanism. Then bend the two side clips, pull the trigger and remove it, then remove the springs.
5
Joystick disassembled. Clean all parts, replace parts as required. Reassemble the controller in reverse order.
Note
The new gamepad can get the hidden screws. In order to remove them, you can break out of the Central pin, which prevents the screwdriver. You can take a thin screwdriver slotted and gradually remove those screws. Also sell special bits and a screwdriver for disassembly devices of this type.
Useful advice
Some screws may be soldered special head. Unscrew them with a special screwdriver TORX 8, which allows the use of various long nozzles.
For the wireless controller it is best to buy a set of special hex screwdriver, used for opening mobile phones. You can buy them in some salons or mobile communication services on repair of mobile devices.
For the wireless controller it is best to buy a set of special hex screwdriver, used for opening mobile phones. You can buy them in some salons or mobile communication services on repair of mobile devices.
