You will need
  • For repair of drain of the tank you will need:
  • - the wrench;
  • - pliers;
  • - a small brush, an old toothbrush;
  • - detergent.
Instruction
1
So, you've started to leak water into the toilet, she goes to a small trickle at his bowl, leaving a rusty trail. Disconnect the water supply to the toilet, cutting off the tap. Drain the existing water from the pot. Take the wrench and disconnect the flexible hose from the receiver. Will hitched the nut securing the float device and remove it. Disassemble into its individual parts. Start to clean them. The inlet valve wipe with the brush and wash with detergent, removing rust. The valve is also clean from deposits, adjust and flush out the mechanism of movement of the float. He should move easily and freely. Assemble the float device and set aside until the side.
2
Unscrew the tank cap, anchored by two bolts from the bowl. There you will see a rubber ring, mash it, wash and rinse. Unscrew the trigger mechanism of the tank. It consists of a fixed lower part of the sealing valve and the movable top. Its main part is rubber or plastic connecting part, which webs adjacent to each other. In the connection have accumulated a lot of rust and sediment. Thoroughly clean their contact parts should be soft and easy to log into each other. Wash them with detergent, attach to each other, look at whether tightly they touch, there are no bends or cracks. They can be lubricated with petroleum jelly for the first time. Clean the tank inside. Assemble the trigger mechanism, put it in place, screw the tank to the bowl. Put the float device. Connect the water. Fill the tank, check to see if he misses the water, if not, all right. If water is still leaking, then buy a new drain device that is suitable for your tank and install it.